Gas sublimator for oxalic acid

The gas sublimator for oxalic acid is practical and very easy to use.

PROCEDURE:
- Screw the gas burner onto the gas cartridge (not included) and then onto the sublimator.
- Prepare an appropriate amount of oxalic acid (approx. 1-2 g) in the supplied measuring doses.
- Turn the sublimator upside down and put a dose of oxalic acid on it. Then turn it back to the upright position so that the oxalic acid powder falls into the sublimator.
- Turn the gas burner on to minimum power.
- When the sublimator is sufficiently heated, the sublimation process will begin and white smoke will begin to emerge from the sublimator.
- Insert the sublimator into the entrance of the hive and wait about 30-45 seconds to sublimate the total amount of oxalic acid.
It is important to turn on the flame of the gas burner to minimum power only for a short time - only so much so that the central chamber of the sublimator heats up and white smoke begins to emanate from the sublimator. Then turn off the burner and, if necessary, turn it on again for a short time.

DURATION OF SUBLIMATION: ca. 30-45 seconds/hive

COMPONENTS:
- gas burner
- gas sublimator
- dosing dose (3x)
*Gas cartridge not included.