Honey heater Dana Api Therma 550W

The honey heater consists of a temperature regulated heating coil. The temperature is regulated through the temperature sensor, which is very important as it protects the honey from overheating and the strainer from damages.

The heating spiral makes it easy to filter even cold or crystallized honey and it can also be used to liquefy honey. You can adjust the temperature between 30-85°C.

Since honey is liquified at about 35-40°C, the heating coil must be adjusted to a temperature higher than this. Operation at higher temperatures is possible without damaging the honey, because the honey will drain away from the heating coil as soon as it is liquified at about 42°C. We recommend that you adjust the temperature between 45-70°C.

Technical data:
Power: 550 W
Voltage: 230 V

RECOMMENDED additional equipment:
- art. 7220, Perforated stainless steel cone, o 32 cm
This cone spreads the heat from the heater and significantly improves the heating performance of the heater as it increases the hot surface area and therefore the heat transfer to the honey.
- art. 7221, Stand for a conical filter, o 32
- art. 7202, Strainer conical, extra fine, o 32 cm